Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Freezer:
1x glass shelf, 1x ice-cube tray
Reversing the door opening:
cap
Installation
Installation
Installation
Installation
Conditions for the installation location
Conditions fo
Conditions fo
Conditions fo
r the installation location
r the installation location
r the installation location
• Good ventilation is required around the appliance
to dissipate the heat properly and to guarantee ef-
ficient cooling operation at low power consump-
tion. Enough clearance is necessary.
Gap to the back approx. 5 cm and to the side
-
walls each approx. 10 cm;
Place the appliance so that the appliance door
-
can open without being impeded.
• Only install at a location with an ambient tempera-
ture suitable for the climate class of the appliance.
For information on the climate class, please refer
to the "EU Product Data Sheet" or to the rating la-
bel located in the interior or on the appliance rear.
• Place the appliance on a steady and safe surface.
If the appliance is not horizontally leveled, adjust
the feet accordingly.
• Avoid the installation:
Avoid the installation:
Avoid the installation:
Avoid the installation:
near heaters, next to a stove, direct sunlight or
-
any other heat sources;
at locations with high humidity (e.g. outdoors,
-
bathroom), as metal parts would be suscepti-
ble to corrosion under such circumstances;
near volatile or flammable materials (e.g. gas,
-
fuel, alcohol, paint, etc.), in rooms which may
have poor air circulation (e.g. garages).
Do not expose the appliance any weather.
-
1x hinge cover,1x blind
Electrical connection
Electrical connection
Electrical connection
Electrical connection
WARNING:
WARNING:
WARNING:
WARNING:
• The installation to the mains supply must conform
to the local standards and regulations.
• Improper connection may cause to an electric
shock!
shock
shock
shock
• Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
• The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
• Make sure that the voltage supply matches the
specifications on the rating label before connect-
ing.
• Connect the mains cable to a properly installed
and earthed wall outlet.
• If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Reversing the door opening
Reversing the door opening
Reversing the door opening
Reversing the door opening
If required, the door openings can be moved from the
right (supplied condition) to the left side.
W W W W ARNING:
ARNING:
ARNING:
ARNING:
When replacing the door stops, the appliance must
be disconnected from the power supply first.
NOTE: : : :
NOTE
NOTE
NOTE
• Ask another person to assist.
You possibly need:
•
driver as well as a thin-blade screwdriver.
* * * * Delivery scope!
•
Keep the parts to be replaced for another possible
door stop change.
19
electric
electric
electric
screw wrench, Phillips screw-
Werbung
