Werbung
Verfügbare Sprachen
Verfügbare Sprachen
NOTE: Do not turn or stop the turntable manually. Moving or jarring the turntable without securing
the tone arm clamp could result in damage to the tone arm.
IMPORTANT!!
•
TO PROTECT THE TURNTABLE FROM DAMAGE DURING TRANSPORTATION, A SILVER
TRANSIT SCREW IS LOCATED AT THE UPPER RIGHT OF THE TURNTABLE.
•
BEFORE PLAYING, PLEASE USE A SCREWDRIVER TO TURN THE TRANSIT SCREW IN
CLOCKWISE DIRECTION (SCREW GOING DOWN) COMPLETELY TO UNLOCK THE
TURNTABLE.
•
TO CLOCK THE TURNTABLE AGAIN FOR TRANSPORTATION, PLEASE TURN THE SCREW IN.
Lithium battery Installation of remote control
•
The remote control requires one CR2025 (3V) lithium battery.
•
Hold and lever pressing the clasp with the thumb in the right direction of the arrow in
the illustration, and take out the battery compartment by sliding with forefinger in
the direction to yourself. Take out the battery compartment from the remote control.
Install a lithium battery (CR2025) in the compartment with the positive polarity
upturned. Level hold and push the battery compartment into the remote control
lightly. It´s okay once hear a click.
CASSETTE CAR
Two common causes of trouble experienced when using cassettes are:
1) Tape jamming - Leading to uneven speed in playback, and 1)
2) Tape tangling - Where the tape wraps itself around vital parts of the mechanism. 2)
To reduce the likelihood of these problems occurring, the following precau-
tions should be observed:
•
Check that there are no loose layers of tape visible through the cassette
center window (see Fig.1). Take up any loose layers, using a pencil or hexa-
gonal barreled ballpoint pen, before inserting the cassette into the machine
(see Fig.2).
•
If the cassette feels „tight" while performing operation shown (see Fig.2),
the tape may be jamming due to „ridges" formed in the winding of the
tape (visible through the center window). These may be removed, in
most cases, by fast winding of the cassette from one end to the other and
back again.
•
Use only well-known brands of tape. Avoid use of C-120 cassettes.
Furthermore, do not expose cassettes to direct sunlight, dust or oil, and do not touch the tape sur-
faces.
TURNTABLE ADJUSTMENT
To make sure the turntable can play the record with different standard completely, a hole with 'NO
OPEN' PVC plate located at the back of the unit to adjust the screw inside the turntable.
When the turntable stop early and auto-return, you use a screw driver
to turn the screw inside the hole about 45 degree in clockwise direc-
tion. If the record still cannot be played completely, stop play and re-
turn the screw 45 degree in clockwise direction again, till the turntable
can play the record completely and then auto- return.
CARE AND MAINTENANCE
17
Werbung
