auna 10008633 Bedienungsanleitung Seite 16

CD OPERATION
1) Press the CD/USB button to enter CD mode, the ‚- - -' and ‚nod' icon will be shown on the screen.
The unit can play CD, CD-R and CD-RW.
2) Press the OP/ CL button to open the CD drawer.
3) Place your disc (MP3 is compatible) in the CD drawer with the label side facing up.
4) Press the OP/CL button again to close the CD drawer. The disc will spin for a few seconds while the
player is reading the disc, then the disc stops spinning and start to play the first track of the disc.
5) MP3 icon will be shown while MP3 is detected. No icon will be shown.
CASSETTE OPERATION
Note: Before inserting a tape in the player be sure
that there is no excess slack in the cassette that
could become jammed in the mechanism. Refer to
the CARE AND MAINTENANCE section for instruc-
tions on removing excess slack from the cassette.
1) Press the POWER button at the front panel 1 se-
cond to turn on the unit and set the volume to a
low level. The POWER indicator comes ‚on'.
2) Press the TAPE button to enter the TAPE mode.
3) Insert your cassette into the slot located on right
side cabinet, as shown in the illustration, with the side you wish to play facing ‚up'
and the open end on the right side.
4) Cassette playback begins as soon as the tape is inserted. Adjust the VOLUME control
to the desired level.
5) To advance the tape rapidly, depress the EJ/F .F (Eject/Fast Forward) button approxi-
mately half way. The tape will move forward rapidly as long as the button is depressed.
Normal playback will resume when the button is released.
6) When the tape ends, the player stops automatically. Depress the EJ/F.F (Eject/Fast
Forward) button completely to remove the cassette from the player. You may press
the EJ/FF (Eject/Fast Forward) button.
7) To turn the system ‚off', press the POWER button3 seconds and the POWER indicator goes 'off'.
PLAYING RECORDS
This system includes a full-size, 3-speed, belt-drive turntable. You can play 33, 45 and 78 rpm records.
1) Press the POWER button at the front panel 1 second and set the volume to a low level.
2) Press the PHONO button to enter the PHONO mode.
3) Make sure that you have removed the stylus cover from the stylus and have released the tone
arm lock that secured the tone arm to the tone arm rest.
4) Set the turntable speed selector to the appropriate speed 33, 45 or 78 rpm. If you are playing
45 rpm ‚singles', place the 45 rpm adapter on the center spindle.
5) Place your record on the center spindle.
6) Raise the cue lever to lift the tone arm off its rest. Move the tone arm to the edge of the record.
The turntable starts automatically. Use the cue lever to gently lower the tone arm onto the record.
7) Adjust the VOLUME control to the desired level.
8) When the tone arm reaches the end of the record it automatically returns to the tone arm rest
and the record player stops.
9) To turn the system ‚off', press the POWER button 3 seconds and the POWER indicator goes ‚off'.
16