Werbung
Verfügbare Sprachen
Verfügbare Sprachen
SITRANS F M electromagnetic flowmeter type MAG 1100 F, DN 10 - DN 100
Installation, welding type
adapter
Installation, clamp type
adapter
3/8" - 4"
The two adapters are welded directly into the
dairy pipes.
It is important to ensure a perpendicular
welding to the pipeline in order to omit mis-
alignment between sensor and adapter fac-
ing.
Installation to be as follows:
1. Cut a piece of the pipeline equal to the
built-in length "L" stated for the actual
sensor dimension.
2. Assemble the sensor and the adapters
with the clamp rings - leave the gaskets
off.
3. Mount the sensor and tag-weld the adapt-
ers to the pipe.
4. Remove clamp rings and dismount the
sensor.
5. The adapters are firmly welded to the
pipe.
6. Re-install the sensor with gaskets and
clamp rings.
Sensor, gaskets and adapters are assem-
bled to one unit and then installed in the
pipeline prepared with a suitable fitting. Stand-
ard gaskets for the actual clamp connection
must be used. The clamp rings must be
located, closed and tightened.
7
Werbung
