KERN KIB-TM Zusatzbeschreibung Seite 50

Menu overview
Menu block Menu item
Main menu Submenu
PO CHK nEt H
Weighing with
nEt L
tolerance range
PCS H
PCS L
BEEP
rELAY
1
P1 r EF
A2n0
Zero point
settings
0AUto
0rAGE
0tArE
P2 COM MODE
Interface
parameter
22
Available settings / explanation
Upper limit value "Tolerance Control Weighing",
Entry
Lower limit value "Tolerance Control Weighing",
Entry
Upper limit value "Tolerance Control Counting",
Entry
Lower limit value "Tolerance Control Counting",
Entry
Acoustic signal for weighing with tolerance range
no
switched off
Acoustic signal sounds when weighed load is
ok
within tolerance limits
Acoustic signal sounds when weighed load is
nG
beyond tolerance limits
Relay pilot light
on
oFF
Automatic zero point correction (Autozero) by changing the
display, digits selectable (0, 0.5d, 1d, 2d, 4d)
Zero setting range
Load range where the display after switching-on the
balance is set to zero. Selectable 0, 2, 5, 10, 20, 30, 50,
100 %
Zero setting range
Load range where the display is set to zero by pressing
. Selectable 0, 2, 4, 10 , 20* , 50, 100%.
Automatic taring „on / off", taring range adjustable in menu
item „0Auto".
CONT S0 off Continuous data output,
selectable „sending 0", yes / no
S0 on
ST1 One output for stable weighing value
STC Continuous data output of stable weighing
values
PR1
•
Output after pressing
•
Precondition for alibi memory
PR2 Manual totalizing
Press and the weighing value will be added
to the summation memory and issued.
KIB-TM-ZB-e-2314