KERN KIB-TM Zusatzbeschreibung Seite 47

I/O interface (Option)
7
(included amongst others in pilot lamp KIB-A06)
The I/O module has two inputs and 8 outputs.
It is possible to connect a pilot lamp that shows an upper and lower limit value.
To enable the pilot light, go to the menu and set the following items:
Menu item to enable the I/O module:

to confirm menu item "P0 CHK"  "rELAy" "on"
Press
Set upper limit value:

to confirm menu item "P0 CHK"  "nEt H"
Press

Use the arrow keys to enter the upper limit value and press
Set lower limit value:

to confirm menu item "P0 CHK"  "nEt L"
Press

Use the arrow keys to enter the lower limit value and press
Manual switching of inputs and outputs (test mode):

Menu item „P9 Prt"  „io"  "o_tSt" (test mode outputs)

Menu item „P9 Prt"  „io"  "i_tSt" (test mode inputs)
• The digit lefthand in the display shows the output number (connected to OUT1-
OUT8 or IN1-IN2)
• The digit righthand in the display shows the current output status:
- „0" means disabled
- „1" means enabled (test voltage is 12V)
Use the arrow keys
(↑) to activate or deactivate the out-/or input (12 V constantly)
Use
KIB-TM-ZB-e-2314
(→) to navigate to the desired output or input.
to confirm
to confirm
19