KERN KIB-TM Zusatzbeschreibung Seite 41

Now enter the IP address for the PC on the display unit:

Menu item "P9Prt"  "oPt""riP_1-4" (IP address PC: 192.168.1.104)

Connect KIB-TM to network (router/switch).

Start Balance Connection

Start Expert mode (See chap. 2)
Adding interface:
- Click on "Add" (green +)
- Click on "TCP/IP Server"
- Tab "IP Port Properties"
Set "TCP – Server listening/waiting"
How to set port:
The settings must match the settings
of the KIB-TM:
„P9Prt"  „opt"  „rPort"
The port must be set to "8080" or
"6000".
It must not be blocked by the router.
Click Apply, close window.
Enable port:
Right-click → Open console
→ Data will be transmitted
(The console is merely used to check
data transmission). All other output
methods can only be set in Balance
Connection.)
• If data transmission is not happening, check the settings described above and re-
enter as required.
• Restart of KIB-TM is required after making changes to WLAN
settings.
• After the restart it may take up to 20 sec until the WLAN module is
displayed.
KIB-TM-ZB-e-2314 13