KERN KIB-TM Zusatzbeschreibung Seite 37

Adding an interface:
- Click on "Add"
- Click on "RS-232 Port (manual)"
- Tab "RS-232 properties"
In Balance Connection choose the
selected COM Port of the PC and set
the interface parameters (baud, data
bit, stop bit, etc.).
Click Apply, close window.
Right-click to enable COM 6 or click
on "Enable Port"
Ensure that balance is switched on.
Right-click on COM 6→Open
Console→ and data will be
transferred
• Now you can set all the other output methods in Balance Connection.
• If data transmission is not happening, check the settings described above and re-
enter as required.
KIB-TM-ZB-e-2314 9