KERN KIB-TM Zusatzbeschreibung Seite 38

Ethernet (optional)
3
The Ethernet allows you to transmit data via cable to devices (such as computers,
printers etc.) that are interconnected in a local network. No direct connection between
KIB-TM and PC is necessary.
Set the following menu items in KIB-TM (See chap. 9)

Menu item "P9 Prt"  "oPt"  "intF"  "EnEt" (Enable output Ethernet)

Menu item "P9 Prt"  "oPt"  "ModE"  " Count" (Output mode continuous
data output)

Menu item "P9Prt"  "oPt"  "iP1-4" Set IP address KIB-TM as follows:
Enter IP address not yet allocated in network:
Example: 10.0.1.104
It is always necessary to enter three numbers according to the following scheme:
10. 0. 1
010 000 001
IP1 IP2 IP3
The same principle is used to configure the following settings:

Menu item "P9 Prt"  "oPt"  "MASK_1-4" (Subnet mask)

Menu item "P9 Prt"  "oPt"  "GATE_1-4" (Gateway)
Now enter the IP address for the PC on the display unit
(If unknown proceed as follows:

Press Windows key and "R" simultaneously

Enter "cmd" and press Enter to confirm

The entry prompt will appear

Enter "ipconfig" and press Enter to confirm

The PC's IP address will appear on the screen)
10
104 IP address
104 Entry sequence in KIB-TM
IP4
KIB-TM-ZB-e-2314