Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Description of
(22) Gas-test button ... for setting the required gas-flow rate on the pressure regulator.
"Comfort"
control panel
(continued)
(23) "Feeder inching" button ... for feeding the wire electrode into the torch hosepack
(24) Keylock switch ... When the key is in the horizontal position, the following
After you press this button, gas will flow out for 30 s. Press the button again to stop
the gas test-flow before the end of this period.
Important! If you press the Store button (21) and the gas-test button (22) at the
same time, the display gives you a read-out of the pre-set gas pre-flow time
(e.g. "GPr | 0.1 s).
-
You can alter the gas pre-flow time with the adjusting dial (1)
If you now press the "Process" button (4), the display gives you a read-out of the
pre-set gas post-flow time (e.g. "GPo | 0.5 s")
- You can alter the gas post-flow time with the adjusting dial (1)
To exit, press the Store button (21).
with no accompanying flow of gas or current
For information on the various wire-inching sequences that are possible when the
welder presses and holds the ""Feeder inching" button", see the section headed
"The Set-up Menu", sub-section " 'Process' parameters", parameter "Fdi".
Important! If you press the Store button (21) and the "Feeder inching" button (23)
at the same time, the display gives you a read-out of the pre-set feeder-inching
speed (e.g. "Fdi | 10 m/min" or "Fdi | 393,70 ipm).
-
You can alter the feeder-inching speed with the adjusting dial (1)
To exit, press the Store button (21).
functions are disabled:
-
Selecting the welding process with the "Process" button(s) (4)
-
Selecting the operating mode with the "Mode" button(s) (5)
-
Selecting the filler metal with the "Material" button(s) (6)
-
Accessing the set-up menu with the "Store" button (21)
-
Accessing the job-correction menu
6 6
Werbung
