Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Description of
(4) Process button(s) ... for selecting the welding process
"Comfort"
control panel
(continued)
(5) Mode button(s) ... for selecting the operating mode
(6) Material button(s) ... for selecting which filler metal and shielding gas you want to
(7) Wire-diameter button ... for selecting the diameter of wire that you want to use.
(8) Welding current parameter ... for selecting the welding amperage. Before the start
(9) Welding voltage parameter ... for selecting the welding voltage. Before the start of
(10) "a"-dimension parameter ... for selecting the "a" dimension. The wirespeed and
(11) Sheet thickness parameter ... for selecting the sheet thickness in mm or in. This
(12) Wirespeed parameter ... for selecting the wirespeed in m/min or ipm. Other
(13) Overtemperature indicator ... lights up if the power source overheats (e.g. be-
(14) HOLD indicator ... every time you finish a welding operation, the actual values for
(15) Arc length correction parameter ... for correcting the arc length
-
MIG/MAG pulsed-arc welding
-
MIG/MAG standard welding
-
Manual process
-
Job mode (Job)
-
TIG welding with touch-down ignition
-
Rod electrode (MMA) welding
-
2-step mode
-
4-step mode
-
Aluminium welding start-up
-
Spot-welding mode
-
Mode
use. Parameters SP1 and SP2 are reserved for additional materials.
Parameter SP is reserved for additional wire diameters.
of welding, the machine automatically displays a guideline value derived from the
programmed parameters. During welding, the actual value is displayed.
welding, the machine automatically displays a guideline value derived from the
programmed parameters. During welding, the actual value is displayed.
Important! The power source has a pulsating open-circuit voltage. Where the "Rod
electrode (MMA) welding" process has been selected, the display indicates an
average welding-voltage value of 40 V before the start of welding (open circuit).
For welding start-up and the main welding operation itself, however, a welding
voltage of max. 50 V (TPS 2700) or 70 V (TS/TPS 4000/5000) is available. Opti-
mum ignition properties are ensured.
welding current / voltage are calculated as a function of the pre-set welding speed.
Important! Before you select the "a"-dimension, the welding-speed parameter (17)
must be set (recommended welding speed for manual welding: ~35 cm/min or
13,78 ipm).
automatically sets all the other parameters as well.
parameters that are dependent on this are also automatically adjusted accordingly.
cause the duty cycle has been exceeded). For more information on this, see the
"Troubleshooting" section.
welding current and voltage are stored, and the "Hold" indicator lights up.
-
shorter arc length
0 neutral arc length
+ longer arc length
4 4
Werbung
