NILS ZDK020 Gebrauchsanleitung Seite 15

As shown in the right figure, connect top pol (W)
and middle pole (X), in order to convenient the next
installation of bolt fixed, please pay attencion to the
direction of holes.
As shown in the above figure, install the triangular
block (Q) on middle pole (X) by bolt (G1), (G2), (G3).
Fix the top pole (W), middle pole (X) and bottom
pole (Y) together by bolt (E1, E2, E3).
As shown in the figure, insert wheel
shaft (V) into the base (BB), wheel (M)
and bottom pole (Y). Please make sure
that the traingular block (Q) must face
to the back after installation.
As shown in the figure, fix the pole brace (U1, U2) on bottom pole (Y) and base
(BB) by bolt (D1, D2, D3) and bolt (J1, J2, J3). Please pay attencion to the upper
and lower directions of the pole brace.
15
USER MANUAL
EN