Herunterladen Diese Seite drucken

Valeo 850232 Montageanleitung Seite 2

Werbung

Step-by-step fitting instructions
Instructions de montage pas à pas
Step 1
EN
WARNING: DO NOT OPERATE THE WINDOW REGULATOR BEFORE IT IS COMPLETELY ASSEMBLY ON VEHICLE. Remove door trim and window regulator.
FR
ATTENTION: NE PAS FAIRE FONCTIONNER LE LÈVE VITRE AVANT DE L'AVOIR COMPLÈTEMENT FIXÉ ET INSTALLÉ DANS LE VÉHICULE. Demonter le leve
vitre.
DE
ACHTUNG: FENSTERHEBER ERST DANN BEDIENEN, WENN ER KOMPLETT UND KORREKT IN DER TÜRVERKLEIDUNG MONTIERT IST. Demontieren Sie die
Türverkleidung und bauen Sie den Fensterhebermechanismus aus.
IT
ATTENZIONE: NON METTERE IN FUNZIONE L'ALZACRISTALLI PRIMA CHE SIA MONTATO COMPLETAMENTE E CORRETTAMENTE SUL PANNELLO
PORTA. Smontare l'alzacristalli.
ES
ATENCIÓN: NO PONER EN FUNCIONAMIENTO EL ALZACRISTAL SIN HABERLO MONTADO ANTES DE MANERA COMPLETA Y CORRECTA EN EL PANEL
DE LA PUERTA. Desmontar el elevalunas.
Step 2
EN
Insert the electric window regulator into the door and secure it into the holes at positions 1, 2, 3, 4 and 5.
FR
Inserer le leve-vitre electrique et le fixer sur les points 1, 2, 3, 4 et 5.
DE
Bauen Sie den elektrischen Fensterheber ein und befestigen Sie ihn an den Punkten 1, 2, 3, 4 und 5.
IT
Introdurre l'alzacristalli elettrico in portiera e fissarlo nei punti n° 1, 2, 3, 4 e 5.
ES
Introducir el elevalunas eléctrico y sujetarlo con los tornillos 1, 2, 3, 4 y 5.
Step 3
EN
Insert the slide 6 into the hole in the glass and fix with the appropriate clip.
FR
Inserer le patin n° 6 dans le trou de la vitre et fixer avec le clip special.
DE
Setzen Sie die Gleitschiene 6 in die Bohrung im Fenster ein und befestigen Sie mit dem geeigneten Klipp.
IT
Inserire il pattino n° 6 nel foro del vetro e fissare con l'apposita clip.
ES
Introducir el patin n° 6 en el hueco del vidrio y fijar con la propria grapa.
Step 4
EN
Wire as per wiring diagram.
FR
Effectuer le liaisons electriques.
DE
Verlegen Sie die elektrische Verkabelung.
IT
Eseguire i collegamenti elettrici.
ES
Efectuar las conexiones eléctricas.
Step 5
EN
Check correct window operation before re-fitting door trim.
FR
Verifier le bon fonctionnement de la vitre avant de remonter le panneau.
DE
Vor der endgültigen Fertigstellung überprüfen Sie die einwandfreie Funktion des elektrischen Fensterhebers.
IT
Controllare il funzionamento dei cristalli prima di rimontare il pannello portiera.
ES
Verificar el funcionamiento del cristal antes de volver a montar el panel de la puerta.
Step 6
EN
PLEASE NOTE! To re-establish the auto function on the replacement regulator, turn the ignition on and operate the window switch to close the window.
FR
ATTENTION! Apres avoir pose la piece de rechange, la fermeture et l'ouverture automatique ne fonctionnent pas. Pour retablir cette fonction veuillez suivre le manuel
d'usage de la voiture.
DE
ACHTUNG! Sollte, nach dem Einbau des Fensterhebers, das automatische Öffnen und Schliessen nicht funktionieren, folgen Sie das Verwendung-Handbuch des
Fahrzeugs.
IT
ATTENZIONE! Dopo che l'alzacristalli ricambio è stato installato, la chiusura ed apertura automatica NON FUNZIONA. Per ripristinare tale funzione utilizzare le istruzioni
del manuale d'uso vettura.
ES
ATENCION! Despues del montaje del elevalunas, las lunas habran perdido la funcion de automatismo, "Comfort". Para restablecer esta funcion, seguir el folleto de las
instrucciones del coche.
/ Schritt-für-Schritt-Montageanweisung /
Istruzioni di montaggio passo per passo
General indications
Recommandations générales
/ Allgemeine Empfehlungen
Raccomandazioni generali
/ Recomendaciones generales
EN
Use a plastic pry tool rather than a screwdriver to remove the door panel.
screwdriver to loosen or tighten the screws, nuts or bolts.
removed easily without leaving any residue or damaging the surface.
of the replacement window regulator, lubricate it with white lithium grease.
window run channels before installation
FR
Utiliser un levier en plastique plutôt qu'un tournevis pour déposer le panneau de porte.
tournevis magnétiques pour serrer ou desserrer les vis et écrous.
maintenir la vitre. Il se retire facilement sans laisser de trace ni endommager les surfaces.
insuffisant des glissières du lève-vitre de remplacement, les lubrifier à la graisse blanche au lithium.
bombe de silicone pour nettoyer les glissières de la vitre avant la pose.
DE
Bitte anstatt eines Schraubendrehers vorzugsweise Kunststoff-Hebelwerkzeug zur Entfernung der
Türverkleidung verwenden.
Zum Lösen oder Festdrehen der Schrauben, Muttern oder Bolzen bitte Magnet-
Schraubenschlüssel und -dreher verwenden.
Klebeband lässt sich leicht entfernen, ohne Spuren zu hinterlassen und die Oberfläche zu beschädigen.
Gleitfläche des Ersatz-Fensterhebers unzureichend gefettet, bitte mit weißem Lithiumfett einschmieren.
Führungsschienen des Fensters vor der Montage mit Silikonspray säubern.
IT
Utilizzare uno strumento di leva in plastica piuttosto che un cacciavite per rimuovere il pannello della portiera.
Utilizzare chiave e cacciavite magnetici per allentare o serrare le viti, i dadi o i bulloni.
carrozziere per assicurare il vetro. Potrà essere rimosso facilmente senza danneggiare la superficie né lasciare
tracce.
Se la guida dell'alzacristalli di ricambio non è abbastanza ingrassata, lubrificarla con grasso bianco al litio.
Utilizzare uno spray al silicone per pulire le guide del vetro prima del montaggio.
ES
Usar una palanca de plástico y no un destornillador para retirar el panel de la puerta.
destornillador magnéticos para ajustar tornillos, tuercas o pernos.
pues se puede retirar sin dejar residuos o dañar la superficie.
nuevo elevalunas, lubricarla con grasa blanca de litio.
elevalunas antes de instalarlo.
/ Instrucciones de montaje paso a paso
Use a magnetic wrench and
Use painter's tape to secure the window. It can be
If there is insufficient grease on the slide area
Use a silicone spray to clean the
Utiliser du ruban de masquage de peinture pour
Zur Sicherung des Fensters Maler-Klebeband verwenden. Das
Usar cinta de pintar para asegurar la ventanilla,
Si no hay suficiente grasa en la parte deslizante del
Usar un aerosol de silicona para limpiar las guías del
Utiliser une clé et un
En cas de graissage
Utiliser une
Ist die
Die
Utilizzare un nastro da
Usar una llave o un

Werbung

loading

Diese Anleitung auch für:

850233