Benelli 302S Bedienungsanleitung Seite 124

Adjusting the headlight beams
The headlight beam adjusting screw is
used to raise or lower the height of the
headlight beams. It may be necessary to
adjust the headlight beams to increase
visibility and help prevent blinding onco-
ming drivers when carrying more or less
load than usual.
Obey local laws and regulations when
adjusting the headlights.
To raise the headlight beams, turn the
screw in direction (A).
To lower the headlight beams, turn the
screw in direction (B).
A
B
Rear shock absorber
The motorcycle is equipped with one rear
shock absorber on the right side
of bike.
Spring pre-load adjustment.
The rear shock absorber is equipped
with adjustment ring nuts for preload
adjustment.
3 - 15
Instrument and control functions
Adjust the spring preload as fol-
lows:
To increase the preload setting of the
spring, turn the adjustment ring nut
with special wrench as illustrated A, to
make the suspension stiffer.
Please rotate opposite direction to
achieve a softer setting. After adjustment,
please make sure the lock nut tightened
to ensure safety of riding.
A
Rebound damping adjustment
The rear suspension rebound damping
can be adjusted by the adjusting knob
in the lower end of rear suspension. To
adjust the rebound damping, please fol-
low the procedure:
1. Turn the adjust knob as illustrated B
B
until feeling tight and no click sound he-
ard, this is the zeroing point with maxi-
mum rebound damping effect. (rebound
extremely slow).
2. Turn the adjust knob in opposite di-
rection, and count for clicking sound. The
total adjustable range is 66 clicks from the
zero point, in normal riding, the setting
should be 5~10 clicks according to the
EN
3