Patron DIXIE Gebrauchsanweisung Seite 6

Always apply the parking brakes, when getting in and out the stroller.
−
The stroller is not designed to by driven down the stairs.
−
Ensure yourself that the fixing accessories, safety bar and other equipment is fitted and adjusted correctly.
−
Do not stand on the footrest.
−
The brakes must be engaged at all times when the stroller is not moving.
−
Getting over the curb practice firstly with an empty stroller.
−
The attendant must take precautions against the fire risk. In buildings, check the location of fire exits and ensure
−
procedures are understood.
Do not let children play with or hang on the stroller.
−
During the drive keep full attention, to avoid any dangerous situation or collisions.
−
Do not overload the stroller. Overloading of a chassis, seat, bag or basket causes reduction of stability of the
−
stroller.
Make the full attention, when manipulate with the stroller, not to injure the child or yourself.
−
If it is possible, always use drive-up ramps or lift to overcome any access restrictions.
−
Always lift the stroller in two persons.
−
Never transport the stroller when you and/or assistance are not sure if you can transport the stroller with the child
−
safely.
When you drive the stroller on the road, follow the road traffic regulations.
−
Do not use the stroller for any other purposes then it is designed for.
−
The stroller is designed to carry only one child.
−
Do not use any other than original PATRON accessories designed for this product.
−
When the stroller is folded and unfolded, the user guide must be followed carefully, to avoid any damage on the
−
construction what could affect the product stability.
In case of apparent defect, which limits product's safe using (e.g. damage of chassis, part falls away or other
−
optically visible defects, cracks etc.) it is necessary to stop using the product immediately and contact your local
official distributor or service centre.
Company PATRON does not bear any responsibility for the damages caused by using other than original PA-
−
TRON accessories supplied by this company.
Company PATRON does not bear any responsibility for the damages and accidents caused by inappropriate use
−
of this product.
PREPARATION FOR USE, USE:
Attaching and removing the seat from the chassis
Attaching: Fix the seat onto "clip- and -go " interface from above , pressure on adapters on each side of the lock .
Ensure proper signals by audible click. Pull the seat up , make sure it is correctly locked ( can not be ejected ) .
Removing : Press both buttons on the outside of the adapter harness , pulling upwards remove the seat from the
chassis .
WARNING ! Pay attention when carrying the seat !
Abductor block
Seat the child into the stroller and find the appropriate place of the wedge. Take the child out of the stroller. Find the
relevant fitting hole on the seat base. Place the wedge in the seat (the narrower part should aim to the backrest) and
secure the wedge by a nut
Headwings
Set the child into the stroller, to determine right height of headwings. Take the child out of the stroller. Put head-
wings in determined height onto the backrest, and secure it using straps with Velcro.
Removing the 5-point belt
Open the 5-point belt buckle.
On the back of the backrest under the seat cushion, release the Velcro shoulder strap. Pull the strap from the back of
the backrest and cover. At the end, pull the treadmill belt clip gradually through a trap in the seat and cover.
Installing a 5-point belt
Pull the belt tensioner clip gradually through the cover, seat. Click the 5-point belt clips. Make sure it is not twisted.
Take the shoulder strap, pull it through the cover. Loosen the velcro fastener on the backrest cover, and strap the
shoulder straps through the trap and backrests of the seat. On the back side of the backrest under the cover, tie the
shoulder straps together by the Velcro.
Assembling the undercarriage
Lay compact undercarriage on the ground, put on all wheels. Remove protective covers of extensible locks on both
ends of handle pipes. Stand between the rear wheels of the stroller on the side of the handle. Brake the undercar-
riage off by pressing the brake pipe to second marginal position, hold your foot slightly on the wheel's axis, grab
the handle and pull it upwards, towards yourself, until you hear a click of the fuses. Make sure that the undercar-
riage is secured by light pushing the handle downwards (the undercarriage cannot be folded now).
Unfolding the undercarriage
Brake the undercarriage off by pressing the brake pipe to second marginal position. With your foot on the pipe, grab
6