Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Dynacode
Operating conditions
Before initial operation and during operation these operating conditions have to be observed to guarantee save and
interference-free service of our devices.
Therefore please carefully read these operating conditions.
As the delivery is customised, please compare the supplied accessories with your order.
General conditions
Shipment and storage of our devices are only allowed in original packing.
Installation and initial operation of our direct print modules is only allowed if operating conditions were fulfilled.
Commissioning is prohibited until it can be established that, where relevant, the machine into which the partly completed
machinery is to be incorporated complies with the provisions of Machinery Directive 2006/42/EC.
Initial operation, programming, operation, cleaning and service of our direct print modules are only recommended after careful
study of our manuals.
Operation of direct print module is only allowed by especially trained persons.
NOTICE!
Organise trainings regularly.
Content of the training are the chapters 'Operating Conditions', 'Loading Media' and 'Maintenance and Cleaning'.
These indications are also valid for someone else's equipment supplied by us.
Only use original spare and exchange parts.
Please contact the manufacturer with respect to spare/wear parts.
Instructions for lithium battery
CPU of direct print module is equipped with a lithium battery (type CR 2032) for which the battery regulation is to apply. This
regulation plans that unloaded batteries have to be given to used battery collecting containers of trade and public carries. In
case that batteries were not completely discharged you have to make arrangements for short-circuits. At a shutdown of direct
print module the battery has to be disposed in either case separately from direct print module.
DANGER!
Danger of life by explosion!
Use nonconducting tools.
Conditions for installation place
The installation place of direct print module should be even, free of vibration and currents of air are to be avoided.
The direct print module have to be installed to ensure optimal operation and servicing.
Installation of power supply
The installation of the power supply to connect our direct print modules has to be effected according to the international rules
and regulations, especially the recommendations of one of the three following commissions:
International Electronic Commission (IEC)
European Committee for Electro technical Standardisation (CENELEC)
Verband Deutscher Elektrotechniker (VDE)
Our devices are constructed according to VDE and have to be connected to a grounded conductor. The power supply has to be
equipped with a grounded conductor to eliminate internal interfering voltage.
94
All manuals and user guides at all-guides.com
English
Werbung
