Workers best WB 600 PS Bedienungsanleitung Seite 20

Dust extraction

The jig saw is equipped with a chip suction nozzle, to which an all-purpose suction

unit or a household vacuum cleaner can be connected. The suction takes place directly

from the saw blade through the suction channel in the vacuum cleaner. A chamber that

is continuously suctioned clear is formed in front of the saw blade with a transparent

protective cover. Advantages of the suction factor: clear view of the cutting area, clean

workspace and air that is clear of sawdust and suitable for breathing.

Initial startup

• Switch on the jig saw and place the saw shoe on the workpiece.

• Slowly move the saw on the previously indicated sawing edge and slowly guide the

jig saw forwards.

• Push the jig saw tightly onto the workpiece. Otherwise the jig saw could vibrate and

the saw blade break.

"Drillsawing"

If the saw is not placed on the side of the workpiece that is to be sawed or if no hole has

been drilled, you have to "drill-saw". This is done as follows:

• Hold the jig saw up to the workpiece with the rounded front of the saw shoe.

• Switch on the jig saw and let the saw blade slowly slide down until it touches the

workpiece.

• Now let the saw do the work and slowly let the saw blade saw into the workpiece.

• Once you have sawed through the workpiece, you can continue to saw with the jig

saw in a normal position.

For this type of sawing you can also first use a drill to drill a hole (which is big enough for

the saw blade of the jig saw). Then proceed according to the steps named above.

Maintenance

Before cleaning or servicing the device, always disconnect the mains plug from the

outlet. Never use water or other liquids for the cleaning of electric parts of the saw.

• Always keep the saw shoe clean so that no imprecisions can occur during sawing.

• Keep the outside of the saw clean, so that all parts can always be moved accurately

and free of wear.

• Keep the ventilation slots of the motor clean so that the motor cannot overheat.

• If the carbon brushes are worn, the jig saw will turn off by itself. In this case you need

to bring the jig saw to your authorised "Workers Best" dealer.

• Lubricate the guide roller regularly.

1247870_Stichsä g e_WB 600 PS_BDA.indd 19

18.01.21 09:38