Werbung
Regulatory Compliance and Safety Information—Cisco Firepower Management Center 1000, 2500, and 4500
Statement 2017—Class A Notice for FCC
Modifying the equipment without Cisco's authorization may result in the equipment no longer complying
with FCC requirements for Class A digital devices. In that event, your right to use the equipment may be
limited by FCC regulations, and you may be required to correct any interference to radio or television
communications at your own expense.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case users will be required to correct the interference at their
own expense.
Statement 2021—Class A Notice for Canada
This Class A digital apparatus complies with Canadian ICES-003.
Statement 7001—ESD Mitigation
This equipment may be ESD sensitive. Always use an ESD ankle or wrist strap before handling equipment.
Connect the equipment end of the ESD strap to an unfinished surface of the equipment chassis or to the ESD
jack on the equipment if provided.
Statement 7003—Telcordia GR-1089 NEBS Standard for
Electromagnetic Compatibility and Safety
Warning
The intra-building port(s) of the equipment or subassembly must use shielded intra-building cabling/wiring that
is grounded at both ends.
Regulatory Compliance and Safety Information—Cisco Firepower Management Center 1000, 2500, and 4500
9
Werbung
