Sym XA05W5-EU Serie Bedienungsanleitung Seite 9

§USE OF BUTTONS§
High/low
beam switch
Turn Signal
Switch
 Electrical starter button
This is a starting motor button(switch) for engine starting.
With the main switch "on", press this button while holding the front or rear brake lever will
start the engine.
CAUTION:
 Release this button immediately after engine has been starter, and never press the button
again to avoid damaging the engine.
 This mechanism is a safety design. The engine can only be started after the front or rear
brake lever (pedal) has been applied.
 Do not use light system. Turn headlight and turn signal light to the "off" position when the
engine is being started.
 High/low beam switch
This is the high and low beam of headlight switching switch. Press this switch to switch between
high and beams.
This is for high beam.
This is for low beam.(please turn to low beam riding in city.)
 Seat open switch
Turn ignition switch to the"ON" position and press this button down. Then, the seat will
Seat open
switch
be open.
This button will return to original position after
releasing.
Press the seat down and it will be locked
automatically.
After the seat catch has been locked , check to
make sure it has locked properly by lightly
lifting the seat.
Seat open
switch
Horn Switch
8
CAUTION:
 Be sure to remove the key after the seat
has been locked.
 Do not put the key inside the storage box
after unlocking to avoid the key being
locked inside the storage box when the
seat is pressed down automatically.
Electrical starter
button