Sage Nespresso Vertuo Creatista SVE850 Bedienungsanleitung Seite 24

TROUBLESHOOTING
EN
PROBLEM
Buttons do not light up.
No coffee.
Coffee is not hot enough.
The machine doesn't start and the Coffee Button light is on
and steady.
The machine has stopped and the coffee or steam button blinks
red continuously.
Coffee light blinks while machine is running.
Coffee light blinks and machine is not running.
POSSIBLE CAUSES
The machine has turned "off" automatically.
•
Check that the water tank is full.
•
Check that a fresh capsule is inserted in the correct position,
•
that the handle is properly locked and push the button to start.
Preheat cup with hot potable water from the tap.
•
Check that the Coffee Lever is properly locked.
•
If brewing coffee, check that a fresh capsule is inserted
•
in the correct position, that the handle is properly locked
and push the button to start.
Check that the water tank is full.
•
If coffee is flowing normally, this indicates the machine
•
is working properly.
If only water is flowing, the machine is executing a user request
•
for either cleaning, descaling or emptying the system.
It will take some time before the coffee flow comes out
•
(due to the barcode being read and parameters being adjusted).
Check that a fresh capsule is inserted in the correct position,
•
that the handle is properly locked and push the button to start.
Fill the water tank and push button to start.
•
24
EASY SOLUTION
Push coffee or steam button to turn machine on.
•
Check the mains, plug, voltage, and fuse.
•
Descale if necessary.
•
Open the machine head and let the capsule be ejected.
•
Then perform a cleaning as per cleaning section.
Descale if necessary.
•
If you are cleaning, descaling or emptying the machine, make
•
sure there is no capsule in the machine, then close, lock it and
push the button to start one of these operations.
Fill the water tank and press the coffee or steam button
•
to restart the process.
Descale if necessary.
•
If there is no intention to clean, descale, or empty the machine,
•
then push the button to stop it. If the machine is still blinking,
exit descaling mode by pushing and holding the button for at
least 7 seconds or refer to next section. If problem persists, call
Nespresso.
Turn the machine to "off mode" by pushing the coffee button
•
for 3 seconds and then push it again to turn the machine "on".
Now wait approximately 20 minutes to allow the machine
to cool down after extensive use.
If the machine doesn't turn "off" then exit descaling mode
•
by pushing the Coffee button for at least 7 seconds.