Hella 1FJ 958 040 Montageanleitung Seite 19

EN
ENGLISH
Mounting steps: Page 8 – 12
It is possible to mount the lights
in an upright or pendant position.
The lights must not vibrate or jut
out above the bonnet, and must be
mounted symmetrically. Determine
the mounting position and mark the
fastening points.
Drill using a 3 mm drill bit, and drill
out to 7 mm. Seal drilled metal
18
parts with rust protection.
When fitting the lights, Ensure that
the light is mounted horizontally.
Align the light in accordance with
the drawing and tighten the screws.
Lay and connect the cables in
accordance with the circuit diagram.
(Page 14, 15)
According to circuit diagram A,
the auxiliary lamps are switched on
together with the existing high-beam
headlamps.
According to circuit diagram B, the
auxiliary lamps are switched on in
addition to the existing high-beam
headlamps via a separate switch.
It is however essential that
country-specific laws are
observed.
Check the lighting system, fasten
the connection cables securely.
Have the auxiliary lamps
adjusted at a specialist garage.
max.
Only correctly adjusted lights
4 m
provide optimum light.
Autogoods "130"
Electrical connection:
page 14, 15
Fit the relay with the connection
terminals pointing downwards in a
waterproof manner. If required and
if legally permitted, fit a switch in
the dashboard.
A useful tip:
Keep the cover lenses clean. Dirt
may absorb up to 80% of the light
emitted.