Beurer MN9X Gebrauchsanweisung Seite 19

5. To switch off the device after use, slide
the ON/OFF controller
display will go out.
10
7.2 Hair clipper
1. Place the hair clipper
from above until they click into place. To
remove the hair clipper
upwards with your thumb.
2. If necessary, select
one of the four comb
attachments
place it on the hair
clipper. Make sure
that you hear and feel
the comb attachment click into place. We
recommend that you start with the comb
attachment with the longest cutting length
initially so you can then slowly work your
way up to your desired length.
3. To switch on the device, slide the ON/OFF
controller upwards. The LED display
9
will start to light up.
10
4. Guide the device slowly through the hair.
Ensure that the comb attachment sits as
flat against the head as possible. Always
100.57_MN9X_2023-06-23_01_put-on-hair-comb_BEU
only trim small areas. Cut the hair against
the direction of growth. If the hair grows
in different directions, use the device in
multiple directions.
5. To switch off the device after use, slide
the ON/OFF controller
display will go out.
10
7.3 Nose/ear hair trimmer
1. Place the nose/ear hair trimmer
the device from above until you hear and
feel it click into place.
2. To switch on the device, slide the ON/OFF
controller upwards. The LED display
9
will start to light up.
10
3. Slowly and carefully insert the tip into
the front part of the nose or ear. Remove
the nose or ear hair using small, circular
motions.
down. The LED
9
onto the device
3
, press them
3
and
4
down. The LED
9
4. To switch off the device after use, slide
the ON/OFF controller
display
7.4 Precision trimmer
1. Place the precision trimmer
device from above until you hear and feel
it click into place.
2. To switch on the device, slide the ON/OFF
controller
10
3. Use the precision trimmer
hard-to-reach places.
4. To switch off the device after use, slide
the ON/OFF controller
display
7.5 Body groomer
1. Place the body groomer
device from above until you hear and feel
it click into place.
2. To switch on the device, slide the ON/OFF
controller
10
3. Guide the device slowly through the body
hair. Ensure that the stainless steel razor
blade sits as flat against the body as
possible. Always only trim small areas. Cut
the hair against the direction of growth. If
the hair grows in different directions, use
the device in multiple directions.
4. To switch off the device after use, slide
the ON/OFF controller
display
onto
5
19
will go out.
10
upwards. The LED display
9
will start to light up.
will go out.
10
upwards. The LED display
9
will start to light up.
will go out.
10
down. The LED
9
onto the
6
for small and
6
down. The LED
9
onto the
7
down. The LED
9