Iberital IB7 Betriebsanleitung Seite 69

Showing the number of litres of water consumed to date.
- Press the MENU button and the display will show:
Showing the number of cycles to date. (Activations for any of the dose selections.)
- Press the MENU button and the display will show:
Showing the total number of coffees dispensed to date.
IMPORTANT: In order to erase the total number of coffees and reset the counter to zero for the total number of
coffees, press the '2 coffees' and '2 espressos' buttons on GROUP 1 (on the left).
The display will then show:
NOTE: Erasing the total coffee count does not erase the reading for the litres of water consumed. To eliminate
the alarm for CHANGE/REPLACE FILTER for the litres of water consumed, see the section WATER FILTER
CHANGE/REPLACEMENT ALARM.
- Press the MENU button and the display will show:
Showing the number of coffees by dose and by group.
Continuing to press the MENU button will show the number of coffees by selection.
NOTE: The individual counter for coffee dose type (1 espresso, 1 coffee, etc.) cannot be erased.
2.9.3.1.2. Technical menu display
Remember that to access the Technical MENU, the display must be in the OFF position (the display will show the
word OFF). If it is in the ON position (the display will show the name entered), in order to access the OFF mode,
press the I/O (ON/OFF) or NON-STOP button on the left button pad and, while pressing it, also press the
TWO ESPRESSOS button on the left button pad immediately after (based on the display used).
Once in OFF mode, in order to access the technical menu, you must press the NON-STOP button on the left
button pad or the MENU button for around 10-15 seconds (based on the display used) and go into technical level
programming mode.
INSTALLATION AND OPERATION MANUAL
All manuals and user guides at all-guides.com
Litres
xxxxxx
Service
xxxxxx
Coffees total
xxxxxx
Coffees total
Total reset
zzzzz GR:
xxxxxx
zzzzz: 1 espresso, 1 coffee, etc.
GR: Group 1/2/3
xxxxx: No. of coffees
IBERITAL
Page 69