Iberital IB7 Betriebsanleitung Seite 56

IBERITAL
- Do not pull the power supply cable to unplug the machine from the socket.
- Do not allow the machine to be exposed to the elements (rain, ice, sand,
etc.).
- Do not expose the machine to temperatures of below 0ºC without having
previously emptied the contents of the boiler and the pipes. If the water in
the interior freezes, disconnect the machine from the water supply and let
the water in the boiler and pipes melt.
- Do not expose the machine as a whole to temperatures above 70ºC.
- Do not allow the machine to be manipulated by children or untrained
persons, or any person who has not read this manual.
- Do not remove the machine side panels in order to reset the high-limit
thermostat. Only official technicians authorized by the manufacturer may
remove the side panels and reset the thermostat.
6) Before carrying out maintenance operations, you must ensure that the machine
is disconnected from the power grid via the switch on the power distribution
system.
7) For cleaning operations, follow the instructions contained in this manual.
8) In the case of anomalies or irregular operation, disconnect the machine prior to
carrying out any maintenance work. Contact the technical personnel authorized
by the manufacturer.
Repairs to the machine will be carried out by the manufacturer or an authorized
after-sales service centre, using only original spare parts.
If these conditions are not met, the machine will pose a danger.
The connection to the power supply must be made via a switch which meets
local safety standards.
9) The electrical supply cable for the machine must be connected to a switch with
a minimum separation between contacts of 3 mm. This switch must be covered
by an omnipolar circuit breaker.
10) In order to keep the power supply cable from overheating, ensure that it is
totally extended.
11) The mains water pressure to which the coffee machine must be connected
must be between 0.6 and 0.8 MPa.
12) The machine is only suitable for installation in places where its use and
maintenance are restricted to qualified personnel.
13) The machine must be installed in a horizontal position, and must
submerged in water or any other liquid.
14) The power supply cable must not be repaired or replaced by the user. Should
the cable become damaged, disconnect the machine from the power supply and
contact qualified technical personnel authorized by the manufacturer.
15) Disconnect the machine from the power supply when it is not going to be
used for an extended period of time.
Page 56
All manuals and user guides at all-guides.com
NEVER
INSTALLATION AND OPERATION MANUAL
be