Scheppach GKS20 Originalbetriebsanleitung Seite 19

• Undiluted strong acids and alkalis
• Organic solvents (such as gasoline, paint thinner,
acetone, heating oil).
In addition, these substances can corrode the materi-
als used on the device.
Warning! This power tool generates an electromagnet-
ic field during operation. This field can impair active or
passive medical implants under certain circumstances.
In order to prevent the risk of serious or deadly injuries,
we recommend that persons with medical implants
consult with their physician and the manufacturer of
the medical implant prior to operating the power tool.
6. Technical data
Mains voltage
Power
Water tank capacity
Suction performance
Protection category
Protection class
Weight
Subject to technical changes!
7. Unpacking
• Open the packaging and carefully remove the prod-
uct.
• Remove the packaging material, as well as the pack-
aging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the product and accessory parts for transport
damage. In the event of complaints the carrier must
be informed immediately. Later claims will not be
recognised.
• If possible, keep the packaging until the expiry of the
warranty period.
• Familiarise yourself with the product by means of the
operating manual before using for the first time.
• With accessories as well as wearing parts and re-
placement parts use only original parts. Spare parts
can be obtained from your specialist dealer.
• When ordering please provide our article number as
well as type and year of manufacture for the product.
m WARNING!
The product and the packaging material are not
children's toys! Do not let children play with plas-
tic bags, films or small parts! There is a danger of
choking or suffocating!
8. Assembly
m ATTENTION!
Prior to use, ensure that the product has been
correctly and fully assembled.
8.1 Installing the machine head (1) (Fig. 1)
1. Place the machine head (1) on the container (4).
2. Secure the machine head (1) with the locking
hooks (3).
3. When installing the machine head (1), ensure that
220-240V~
the locking hooks (3) latch into place correctly.
50/60 Hz
1200 W
8.2 Installing the HEPA filter (9) (Fig. 3)
20 l
1. Put the HEPA filter (9) on the machine head (1)
from below.
18 kPa
IP20
8.3 Installing the suction hose (5) (Fig. 4, 5)
II
1. Connect the suction hose (5) to the corresponding
approx. 3 kg port, depending on the desired use, on the wet and
dry vacuum cleaner.
8.4 Vacuuming (Fig. 4)
1. Connect the suction hose (5) to the suction hose
connection (6). To do so, slide the end of the suc-
tion hose (5) with the two nipples into the suction
hose port (6).
2. Insert the two nipples into the recesses.
3. Once the suction hose (5) is fully inserted, turn it
clockwise.
8.5 Blowing (Fig. 5)
1. Connect the suction hose (5) to the blowing func-
tion connection port (7). Slide the end of the suc-
tion hose (5) with the two nipples into the blowing
function connection port (7).
2. Insert the two nipples into the recesses.
3. Once the suction hose (5) is fully inserted, turn it
clockwise.
8.6 Fit the suction hose (5) and the aluminium
nozzle (8) (Fig. 6)
1. Push the aluminium nozzle (8) onto the end of the
suction hose (5).
www.scheppach.com GB | 19