Bringing the front plate into a level position.
A
D
A
Carefully remove the front plate using a screwdriver
(click-lock system).
B
Unscrew the mounting clip using a screwdriver.
C
Flip the mounting clip 180°.
D
Feed the screw into the rear opening.
E
The mounting clip's nose points downwards –
adjust 1 mm downwards – fasten the mounting clip
again until it aligns with the tiles.
F
The mounting clip's nose points upwards – adjust 1 mm
upwards – fasten the mounting clip again until it aligns
with the tiles.
OCEAN B7
B
E
C
F
Mounting clip:
Can be turned into any
direction and then
inserted into the guide rail.
Nose points
downwards
Nose points
upwards
SanTec OCEAN B7
Bath fitting
EN
Nose in centre
position
Nose in centre
position
23