Santec OCEAN B7 Montageanleitung Und Bedienungsanleitung Seite 22

EN
Assembly
13
16
Item A
!
ATTENTION!
Perform the following steps
in the order indicated!
SanTec OCEAN B7
22 Bath fitting
OCEAN B7
14
17
13.
Place the mixing shaft into the central position – the dot
should point upwards.
14. Place the mixing lever into the central position – the knob
should point upwards.
15. Put the glass front plate into place by carefully pushing in
inwards (click-lock system).
16.
Check whether the front plate is level.
If not, correct the alignment as described on page 23.
17. Open the main water valve.
18. Perform a system test.
For instructions on how to program the three fill level icons
for automatic tub filling, see page 26.
15
> Click <
18