Santec OCEAN B7 Montageanleitung Und Bedienungsanleitung Seite 21

Assembly
7
10
7.
Configure the desired functions at the electronics module
(see p. 19).
8. Connect the power cables to the electronics module.
Make sure to use the correct polarity (+/-).
9. Connect the magnetic valves for the tub and shower to the
electronics module.
10. Connect the cable between the glass front plate and the elec-
tronics module. Then switch on the power (causing the safety
locking mechanism of the magnetic valves to activate).
11. Open both integrated stop valves using a screwdriver.
12. Insert the electronics module into the designated slot.
OCEAN B7
8
+ -
11
9
12
Perform the following steps
in the order indicated!
SanTec OCEAN B7
Bath fitting
EN
!
ATTENTION!
21