Werbung
en
Empty the dust container over a bin
and lift the pre-filter upwards to re-
move it (Fig. 30).
Clean the dust container using water
and mild washing-up liquid.
Dry the dust container thoroughly.
Reinsert the pre-filter in the dust con-
tainer and turn the pre-filter back to
its original position (Fig. 32 + 33).
Reattach the dust container to the
PowerUnit connector.
Cleaning the Electrobrush (Fig. 34)
Disconnect the Electrobrush from the
vacuum cleaner (Fig. 10).
Place the Electrobrush upside down
on a level, clean surface.
Cut any threads or hairs that have
wound themselves around the roller
brush with a pair of scissors. To guide
the scissors, move along the guide
track on the roller brush.
Then run the vacuum cleaner to va-
cuum up the cut threads and hairs.
If the small running wheels are very
heavily soiled or blocked, you can re-
move them for easier cleaning. To re-
move them, use a flat-head screw-
driver.
Removing the roller brush from the
Electrobrush (Fig. 35)
You can take the roller brush out of the
Electrobrush in order to remove stub-
born soiling and clean the inside of the
Electrobrush.
78
Unlock the cover on the side of the
Electrobrush so that the symbol
becomes visible a.
Lift the cover up as far as it will go b.
Remove the roller brush c.
Remove the roller brush handle if you
identify heavy soiling there d.
Clean the roller brush and the roller
brush handle, and remove any stub-
born soiling inside the Electrobrush.
Reassemble the Electrobrush in re-
verse order.
Replacing the rechargeable battery
An original Miele AP01/AP02/AP03 lith-
ium-ion rechargeable battery (HX LA) is
required.
Follow the instructions regarding the
handling and disposal of rechargeable
batteries found in the following sec-
tions: "Warning and safety", "Caring
for the environment" and "Installation
and connection - General battery in-
formation").
Werbung
