Climadiff CVP185A++ Gebrauchsanweisung Seite 52

Adjusting the thermostat
Tip: immerse a suitable thermometer in a clear glass bottle filled with water
and place it in the middle of the cellar. Wait at least 24 hours before
checking the temperature.
ligths when the
compressor is
working, during
cold cycles
The temperature range can be set as low as 5°C or as high as 18°C to suit your
specific storage requirements. The acquiescence temperature setting is 12°C.
How to set the temperature:
The temperature preset in factory for this model is 12 ° C. SET and the arrows are
used to change settings. To change the temperature:
• Press SET, "SP" will be shown on the display and press SET again and the
current value will be shown
• Press simultaneously SET and the upper arrow
• Press UP or DOWN arrows to change the set point value between 5 and 18°C
• Press SET to accept the new value
• Press SET and down arrow at the same time to exit the programming mode or
wait 1 minute to automatically exit
The thermostat in your wine cellar only controls the production of cold air. If your
wine cellar is equipped with the winter system and is intended for use in an
unheated area, the heating circuit is factory preset and you do not need to adjust
it.
Don't worry if your thermometer doesn't indicate exactly 12°C! Inertia of liquid with
respect to air is a factor of 1 to 10 and your cellar will make the necessary
corrections automatically.
°C shows the
temperature
value unit
52