Werbung
Verfügbare Sprachen
Verfügbare Sprachen
RC10.4 70, RC10.4 90
I
NOTE
• Attach the side walls or the attached strips so that the screws are
tight, even when under increased loads (while driving).
• The refrigerator is designed to provide a regulated air flow. The man-
ufacturer does not recommend to leave additional space between
the refrigerator and the recess walls.
Proceed as follows (fig. c, page 11):
➤ Move the refrigerator into its final location.
➤ Fasten the four screws through the four plastic washers in the sides of the
refrigerator into the recess wall.
➤ Put the caps onto the screw heads.
8
Operation
I
NOTE
Before starting your new cooling device for the first time, you should
clean it inside and outside with a damp cloth for hygienic reasons
(please also refer to the chapter "Cleaning and maintenance" on
page 28).
8.1
Energy saving tips
• Choose a well ventilated installation location which is protected from direct
sunlight.
• Allow food to cool down first before placing it in the device.
• Do not open the cooling device more often than necessary.
• Do not leave the door open for longer than necessary.
• Defrost the cooling device as soon as a layer of ice forms.
• Avoid unnecessarily low temperatures.
• Clean the condenser of dust impurities at regular intervals.
8.2
Using the refrigerator
The fridge device conserves fresh foodstuffs. You can also conserve frozen foodstuffs
in the freezer compartment.
EN
Operation
25
Werbung
