ABB STD-MTS Betriebsanleitung Seite 26

Commissioning
Adjusting the basic brightness (if required)
• Hold the operating element down for about 30 seconds
to get into programming mode.
- The memory touch controller STD-MTS has switched
to „programming mode" when it jumps automatically to
a minimum brightness value.
• Adjust lamps to the desired brightness value and release
key.
- About 30 seconds after releasing, the memory touch
controller STD-MTS jumps back onto maximum again.
This is the sign that the adjustment works have been
properly completed.
- If this does not occur, please try to adjust the basic
brightness again.
GB