Rear Shock Absorber; Adjust Shock Absorber - SXT-Scooters ultimate pro Benutzerhandbuch

E

Rear shock absorber:

1. Open the screws with a 5 mm Allen wrench
Front shock absorber:
1. Open the screws with a 5 mm Allen wrench

Adjust shock absorber

(Note that the pump is not included in the delivery. SXT-Scooters offers these as accessories)
2. push the shock absorber a little further
in front, to fill air better in the filler neck
to pump. Not more than 150psi or 10 bar.
2. push the shock absorber a little back, to fill air
better in the filler neck to pump. Not more than
150psi or 10 bar.
Slide the screw and washers back in and tighten the
screw again.
Slide the screw and washers back in and tighten the
screw again.