Werbung
Verfügbare Sprachen
Verfügbare Sprachen
User manual / Bedienungsanleitung
Is the record or the stylus dirty
or damaged?
Needle bounces
Has the tracking force been set
or slides across
too high or too low?
record
Is the record deformed or
scratched?
Is the turntable leveled?
Is the antiskating set too high/
low?
Is the drive belt properly
attached?
Is the power cord connected
properly?
Platter does not
turn
Is the power switch in the
correct position?
The turntable is still in standby
mode.
Is the drive belt properly
attached?
Noisy sound
Contact problems with the signal
connections (e.g. cinch plugs,
adapters for extensions)
Humming noises
The pickup pins are mixed up, not
connected correctly or defective.
Wrong speed selected.
The music doesn't
sound like
usual
The turntable is spinning too
fast/too slow.
Made in Germany
Clean the record / or the cartridge. Clearaudio
offers many helpful accessories for care and
cleaning. In the event of damage, we recommend
an assessment by a specialist and, if necessary,
an exchange.
Adjust the tracking force.
Use a record clamp or replace the record.
Check the alignment of the turntable and adjust
if necessary.
Contact your dealer to have the setting checked
and corrected if necessary.
Check the position of the drive belt.
Check the connection.
Check the switch on the back of the device.
Activate the drive by pressing the button.
Check the position of the drive belt.
Is it too loose and needs to be changed? Please
note: After changing the belt, we recommend
recalibrating the turntable.
Check all connections; reduce the level on the
(pre-)amplifier to a low volume for acoustic
checking of gross errors.
Check the pin assignment of the pickup.
Check the record for recommended speed.
There are also records in LP format (30 cm) that
have to be played at 45 rpm ("maxi singles") and
small records in single format (17 cm) that have to
be played at 33 rpm (so-called " EP's").
Start the self-calibration using the operating
instructions.
Loving music
Page / Seite 15
Werbung
