clearaudio electronic Concept Signature Bedienungsanleitung Seite 11

User manual / Bedienungsanleitung
4. Initial operation and calibration of speed
Pic. 9: Control unit of the
4.2 Calibration of speeds
Thanks to the newly developed motor control, the
maintain the perfect speed.
However, manual calibration is possible. This is particularly recommended if the turntable has not
been in use for a long time, wearing parts (e.g. belts) have been replaced or the drive is being
repositioned after moving, for example.
If you would like to start the calibration manually, please proceed as follows to recalibrate both
speeds. This process can take up to 10 minutes.
Pic. 10: Calibration of the
After calibration is complete, the turntable stops and switches to standby mode by itself.
Made in Germany
concept Signature
concept Signature
4.1 Initial operation
concept Signature
If the
button once to put the drive into operation at the
basic speed of 33 1/3 rpm.
Press again to change the speed to 45 rpm.
Another press puts the drive back into standby mode.
We recommend to let the turntable run in for around
15-30 minutes when using it for the first time.
concept Signature
The turntable have to be in standby mode to start
the calibration. On the back of the turntable you
will find the calibration button next to the "On/Off"
switch.
Since this is recessed in the chassis, you need a
narrow screwdriver or alternatively a ballpoint pen
or something similar to press the button.
Hold this down for approx. 5 seconds. As the
turntable calibrates itself, the platter rotates and
the display quickly changes between 33 (=33 1/3)
and 45.
Loving music
is in standby, press the
calibrates itself to always
Page / Seite 11