clearaudio electronic Concept Signature Bedienungsanleitung Seite 13

User manual / Bedienungsanleitung
5.2 Adjustment of the tonearm height
Since everything on the turntable is pre-assembled
and tested, including tonearm and cartridge, there
is usually no need to change any parameters on the
concept Signature
turntable. If you wish to change
the height of your tonearm, please refer to your
nearest qualified dealer or service personnel.
Your dealer can make the height adjustment by
loosening the locking screw on the side of the
tonearm base of your turntable.
Please note that the basic setting is made without
an additional mat on the plate.
Clearaudio assumes no liability for incorrect handling or any damage caused if non-qualified
persons attempt the above adjustments.
5.3 Adjustment of the anti-skating force
Again, since everything on the turntable is pre-
assembled and tested, including tonearm and
cartridge, there is usually no need to change any of
concept Signature
the
If you still want to change the anti-skating, please
contact your dealer, who has the necessary
accessories, e.g. test record, measuring tool.
Your specialist dealer will find the anti-skating screw
on the underside of the
Clearaudio assumes no liability for incorrect handling or any damage caused if non-qualified
persons attempt these adjustments.
Made in Germany
turntable parameters.
concept Signature
turntable.
Pic. 13: Adjustment of the tonearm height
Pic. 14: Adjustment of the anti-skating
Loving music
Page / Seite 13