Setting The Spotlight Into Operation; Operation; Operation Without Dmx Controller; 7�1 Master / Slave Operation - IMG STAGE LINE WASH-42LED Bedienungsanleitung

5 Setting the Spotlight
into Operation
WARNING
To prevent damage to your eyes,
never look directly into the light
source for any length of time .
Please note that fast changes in lighting may
trigger epileptic seizures with photosensitive
persons or persons with epilepsy!
Connect the mains cable provided to the mains
jack (3) and then to a socket (230 V/ 50 Hz) . The
unit is then ready for operation and may be
operated via a DMX light controller (
ter 8) or may independently execute the control
program that has been set (
switch off the unit, disconnect the mains plug
from the socket .
Caution: Do not connect the unit to the mains
voltage via a dimmer!

6 Operation

To define the unit settings, use the system menu
which can be operated by means of the buttons
(1) and the display (2) . After power switch-on,
the moving head will first conduct a reference
move for position adjustment; then the oper-
ating mode most recently set will be indicated
on the display .
The functions of the buttons are as follows:
– MENU to select a menu item
– UP and DOWN to set values or menu options
– ENTER to call up a menu item and to save a
modification
The menu structure is shown in chapter 10 .2 .
Refer to chapters 7 to 9 while using the buttons
to make the settings desired for the respective
operating mode . The display extinguishes some
seconds after the last button was pressed and
will reappear when a button is pressed .
Important: To make sure that a setting is stored
on the unit and is available after the unit has
been switched off and on, always press ENTER
to confirm the setting you have changed .
14
☞
chap-
☞
chapter 7) . To
7 Operation without
DMX Controller
The unit provides automatic show programs and
a program that can be music-controlled via the
internal microphone . To call up one of these
programs:
1) Press the button MENU repeatedly until the
display indicates one of the following operat-
ing modes:
, ,
2) Use the button UP or DOWN to select the
program desired:
: fast movements
: slow movements
: slow movements, different colour
se quence
: music-controlled movements and
light changes
3) Press the button ENTER . The program starts
and the alternative indication for the pro-
gram selected appears on the display:
: fast
➔
: slow
➔
: slow, different colour
➔
sequence
: music-controlled
➔
7.1 Master / slave operation
Multiple WASH-42LEDs can be operated in sync .
In this mode, one unit (master unit) controls the
other units (slave units) . Connect the units in a
chain . Please also refer to chapter 8 .1, ignoring
step 1 .
On the master unit, call up an automatic or
music-controlled program . Proceed as follows to
set the slave units to slave operation:
1) Press the button MENU repeatedly until the
display indicates one of the following operat-
ing modes:
, ,
2) Use the button UP or DOWN to select the
operating mode
3) Press the button ENTER . The display changes:
➔
, , ,
, , .
, , ,
, , .
.
, ,
, ,