Datastation Maxi Z.ul; Changing The Mode Of The Trekstor; In The Ndas Device Manager; Using The Trekstor - TrekStor DataStation maxi z.ul Handbuch

3.4) Change the mode of the TrekStor
maxi z.ul
A menu opens if you right-click on the symbol for the "NDAS D
M "- in the Info area of the task bar. To change the status of a
ANAGER

DataStation maxi z.ul

desired mode in the context menu that appears.
Two different modes can be selected:
a) In the "M (R
OUNT

DataStation maxi z.ul

b) In the "M (R
OUNT
DataStation maxi z.ul
access to the
Under the "P
ROPERTIES
DataStation maxi z.ul
about the
enter the write key of the
"G " register using the "A
ENERAL
to it.
Note: The identification number (ID) and the write key (KEY) can be found on
DataStation maxi z.ul
your

3.5) Using the TrekStor

After you have successfully registered and mounted the
maxi z.ul
, it appears under "M
use it as a hard disk located on the PC.
Note: If you have mounted the
mode, the disk is write-protected.

in the NDAS Device Manager.

, mark it in the menu and select the
)" mode, you only have read access to the
EAD ONLY
.
/ W )" mode, you have both read and write
EAD RITE
" entry, you can obtain miscellaneous information
DataStation maxi z.ul
" button, in order to obtain write access
DD
DataStation maxi z.ul
C
Y OMPUTER
DataStation maxi z.ul
– 39 – – 39 –

DataStation

.
. There, if applicable, you can
or on the reverse side of the quick guide.
DataStation
" as a "L D
OCAL
EVICE
under the
". You can now
ISK
in read
EN