Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3 Power supply
3.1 Operating with the
power adapter
Check that the voltage indicated
on the rating plate of the power
adapter corresponds to your local
power supply.
The only way to disconnect the ap-
pliance from the power supply is to
unplug the power adapter.
1. Plug the charging plug into the
appliance socket and the power
adapter into the wall socket.
CAUTION!
A
groove on the charg-
ing plug must match
the notch in the ap-
pliance socket.
– LED lights will lit up one
after another until it's fully
charged. After full charge,
lights will go out completely.
C
Charging time: 1.5
hours when the bat-
tery is fully charged
36 / EN
2. LED lights will start flashing
when the unit reaches low
battery
operation.
– When the batteries are
discharged: LED lights will
not display.
C
The
C
C
Hair and Beard Clipper / User Manual
capacity
during
Discharge the ap-
pliance
through
normal use. Then
recharge to full ca-
pacity.
Maximum
battery capacity will
only be reached af-
ter several charging/
discharging cycles.
The adapter and unit
may become warm
while charging; this
is normal operation.
When the appliance
is fully charged, it
has a cordless op-
erating time of up to
70 minutes.
Werbung
