EuroLite IP AUDIENCE BLINDER 2x100W LED COB RGB+WW Bedienungsanleitung Seite 20

INSTALLATION
WARNING! Risk of injury caused by falling objects
Devices in overhead installations may cause severe injuries when crashing down. Make sure
that the device is installed securely and cannot fall down. The installation must be carried out by
a specialist who is familiar with the hazards and the relevant regulations.
The device may be placed on the floor or fastened to a truss or similar rigging structure. The device must
never be fixed swinging freely in the room.
1 The rigging structure must support at least 10 times the weight of all fixtures to be installed on it.
2 Block access below the work area and work from a stable platform when installing the device.
3 Use rigging hardware that is compatible with the structure and capable of bearing the weight of the
device. Please refer to the Accessories section for a list of suitable rigging hardware.
4 Secure the device with a safety bond or other secondary attachment. This secondary safety attachment
must be sufficiently dimensioned in accordance with the latest industrial safety regulations and
constructed in a way that no part of the installation can fall down if the main attachment fails. Use the
hole in the bracket for fixation of the safety bond. Fasten the safety bond in such a way that, in the event
of a fall, the maximum drop distance of the device will not exceed 20 cm.
5 To align the device, release the fixation screws at the mounting bracket, adjust the desired inclination
angle and tighten the fixation screws.
6 After installation, the device requires inspections periodically to prevent the possibility of rot, deformation
and looseness.
Attaching the frost filter
For a homogeneous and soft light of the Audience Blinder, please use the enclosed frost filters.
Attach one frost filter onto each lens of the device with the screw heads facing inward. The frost filters must
fit snugly directly onto the lenses via notches on the frost filters above the stud bolts as well as on the device
housing. Rotate the frost filters by 90° to the right to prevent accidental release
20/28 00148383, Version 1.0