tiki GBFU 50 E5 Gebrauchsanweisung Seite 19

warm water. When the water in the heater is cooled, close the flow of cold water into
the heater and unscrew the flexible pipe on the warm water outlet. The heater can
now be drained through the outlet valve on the inlet pipe. After draining the water
through the inlet pipe, a small quantity of water remains in the heater. When refilling
the heater with water it is recommended to open the warm water tap on the mixing
tap and let the water run for at least two minutes through the outlet pipe (the water
stream should be steady, medium strength, about as thick as a pencil).
MAINTENANCE
Clean the exterior of the heater using a soft cloth and mild detergent intended for
cleaning smooth varnished surfaces. Do not use detergents that contain alcohol or
abrasives. With regular service inspections you will ensure faultless functioning and
long life of the heater. Tank corrosion warranty applies only if all the prescribed
regular inspections of the protective anode wear have been made. The period
between regular inspections should not be longer than stated in the warranty
certificate. Inspections should be carried out by authorised service providers that will
record each inspection on the warranty statement of the product. Upon inspection the
service provider will inspect the amount of wear on the anti-corrosion anode and, if
necessary, clean the limescale that accumulates depending on the quality, quantity
and temperature of the water inside the heater. The service provider will also
recommend the date for the next inspection depending on the condition of the heater.
Please do not attempt to fix any defects of the heater by yourself. Call the
nearest authorised service company.
19