tiki GBFU 50 E5 Gebrauchsanweisung Seite 16

CONNECTING THE WATER HEATER TO
THE POWER SUPPLY NETWORK
Fig. 5: Removing the protective cover
Fig. 6: Electric installation
CAUTION: Before any intervention into the interior of the water heater,
disconnect it from the power supply network! This intervention may only be
performed by a trained professional!
USE OF THE HEATER
After it has been connected to the water and power supply grid, the heater is ready to
be used. When connected to the power supply, the heater runs in standby mode. In
the standby mode, the heater maintains the water temperature of 10 °C.
16
Before connecting to the power supply network, install a
power supply cord in the water heater, with a min.
2
diameter of 1.5 mm
the protective plate must be removed from the water
heater.
In the electrical installation, please install a disconnect
switch to separate all poles from the power supply
network in accordance with the national regulations.
(H05VV-F 3G 1.5 mm
Legend:
1 - Connection terminal
2 - Thermal cut-out
3 - Electronic regulator
4 - Electric heating element
5 - Temperature sensor
L - Live conductor
N - Neutral conductor
- Earthing conductor
2
). To do this,