tiki GBFU 50 E5 Gebrauchsanweisung Seite 17

The heater is equipped with the "EcoSmart" electronic regulator, which enables the
setting of water temperature, error diagnostics and smart mode with which you can
reduce the use of electric energy.
Switching the heater on/off
The water heater can be switched on by holding the
By holding the button for about 3 seconds again, the heater goes into standby.
Operating the heater – manual setting
Temperature is set by pressing button
(preset temperature level is 57 °C).
- Freeze protection, temperature about 10 °C.
- Water temperature about 35 °C.
- Water temperature about 57 °C.
- Water temperature about 75 °C.
Once the maximum level "
temperature to the first setting "
the most energy-efficient. The temperature of water is about 57 °C, while limescale
production and heat loss will be smaller than in case of higher temperature settings.
The temperature of water in the heater is indicated on the display
If the heater will not be used for a longer period of time, please protect its contents
from freezing by setting the temperature to the "
heater will maintain the temperature of water at about 10 °C.
Functioning of the heater in the "EcoSmart" mode
This mode is appropriate especially if you have well-established hot water
consumption habits (e.g. showering every day at approximately the same time). To
Legend:
- display of the set/actual temperature of water in the
heater, signalisation of errors
- On/Off button, temperature setting
- indication of the "SMART" function
- switch for the "SMART" function
Fig. 7: Control panel
until you get the desired temperature level
" is achieved, pressing the
". We recommend the "ECO" setting. This setting is
button for about 3 seconds.
button returns the
.
" position. At this setting, the
17