Hohem iSteady M6 Benutzerhandbuch Seite 16

Auto Calibration and Firmware Update
Calibration Reasons and How to Calibrate
Auto calibration could reduce drift or slight deviation caused by nearby magnetic
interference or human error.
Note: Calibration failure might happen if the gimbal is not placed on a flat surface
for calibration (e.g., calibration in a running vehicle).
Place the gimbal on a flat surface by
means of a tripod.
Press the M button five times to enable
the auto calibration and you will hear a
beeping sound. Please do not touch the
gimbal during calibration.
Two short beeps, following the calibration failure, indicate that the gimbal has been in
the standby mode. Any button (except the joystick) can wake up the gimbal. Then, follow
the steps above to re-calibrate.
1
3
Double press the trigger to recentre the
The second beep indicates that the
calibration is completed, and the gimbal
will be recentred automatically.
16
2
gimbal.
4