Werbung
Verfügbare Sprachen
Verfügbare Sprachen
circuit breaker or fuse. Never clean
the appliance with a steam cleaner
Moisture could accumulate in
electrical components, danger of
electrical shock! Hot vapors can lead
to the damage of plastic parts. The
appliance must be dry before it is
placed back into service.
Important! Ethereal oils and organic solvents can
attack plastic parts, e.g. lemon juice or the juice
form orange peel, butyric acid, cleanser that contain
acetic acid.
x
Do not allow such substances to come into
contact the appliance parts.
x
Do not use any abrasive cleaners
x
Remove the food from the freezer. Store them
in a cool place, well covered.
x
Switch the appliance off and remove the plug
from the mains, or switch off or turn out the
circuit breaker of fuse
x
Clean the appliance and the interior accessories
with a cloth and lukewarm water. After cleaning
wipe with fresh water and rub dry.
x
After everything is dry place appliance back into
service.
Troubleshooting
Caution! Before troubleshooting,
disconnect the power supply. Only a
qualified electrician of competent
person must do the troubleshooting
that is not in this manual.
Important! There are some sounds during normal
use (compressor, refrigerant circulation).
If the malfunction shows again, contact the Service
Center
These data are necessary to help you quickly and
correctly. Write the necessary data here, refer to the
rating plate.
Problem
Possible cause
Mains plug is not
plugged in or is
Appliance dos not
loose
work
Fuse has blown or
is defective
Socket is
Appliance freezes
defective
or cools loo much
Solution
Insert mains plug.
Check fuse,
replace if
necessary.
Mains
malfunctions are
to be corrected
by an electrician.
Problem
Possible cause
Temperature is
set too cold or
the appliance
runs at SUPER
modes,
Temperature is
not properly
adjusted.
Door was open
for an extended
period.
The food is not
A large quantity
frozen enough.
of warm food was
placed in the
appliance within
the last 24 hours.
The appliance is
near a heat
source.
Door seal is not
air light.
Heavy build up of
frost on the door
seal.
Appliance is not
level.
The appliance is
touching the wall
or other objects.
A component,
Unusual noises
e.g. a pipe on the
rear of the
appliance is
touching another
part of the
appliance or the
wall.
It's normal. Heat
Side panels are
exchange is in the
hot
side panels.
If the malfunction shows again, contact the Service
Center.
These data are necessary to help you quickly and
correctly. Write the necessary data here, refer to the
rating plate.
Solution
Turn the
temperature
regulator to a
warmer setting
temporarily.
Please look in the
initial
Temperature
Setting section.
Open the door
only as long as
necessary.
Turn the
temperature
regulation to a
colder setting
temporarily.
Please look in the
installation
location section.
Carefully warm
the leaking
sections of the
door seal with a
hair dryer (on a
cool setting) At
the same time
shape the
warmed door seal
by hand such
that it sits
correctly.
Re-adjust the
feet.
Move the
appliance slightly.
If necessary,
carefully bend
the component
out of the way
Take gloves to
touch side panels
if need.
Werbung
