Binding; Trim - Carson Reflex Stick Multi Pro LCD 14 Channel Betriebsanleitung

BINDING

Assigning a transmitter identifier to the receiver (binding)
In addition to control information, when the remote control is
operating, an electronic identifier is sent with each transmitter
impulse. This is how the receiver recognizes that the signal has
come from its own transmitter. Since many millions of transmitter
identifiers are available, it is extremely unlikely that a different
transmitter could influence your receiver.
1
1. Turn on the receiver power. Press the SW switch.
The receiver's LED should start flashing.
3
3. When the LED on the receiver becomes solid, the binding
process is completed. The RC system is ready.

TRIM

Trim is used primarily to correct a slight slanted position of the
servo lever. In addition, one has the option of precisely readju-
sting the model during operation, if it does not travel in a straight
2
1
Upon first use, however, the transmitter must communicate this
identifier to teach each new receiver. For this purpose, the follo-
wing process is necessary. To the degree possible, it should be
undertaken at a place where no other electrical signal – especially
not one from another 2.4 GHz transmitter – can interrupt this
transmission over the radio path.
2
2. Turn on the
transmitter.
line, for example, even though the control wheel is in the centre
position. Trim for CH1-CH4 - Example illustration: 1. Trim CH2 / 2.
Trim CH4.
21 // GB