Connections To Receiver; Install The Transmitter Batteries - Carson Reflex Stick Multi Pro LCD 14 Channel Betriebsanleitung

CONNECTIONS TO RECEIVER

Battery eliminator is installed in the receiver circuitry. The receiver
gets supplied with current through the drive battery that runs the
engine. NiMH battery from 6 V to 8.4 V can be used for the receiver.
Batteries of higher voltage may damage the receiver and servos.
Electronic speed controller
(not included)

INSTALL THE TRANSMITTER BATTERIES

1. Open the battery compartment lid on the reverse of the
transmitter.
2. Insert 4 fully charged rechargeable batteries or new AA
batteries observing the correct polarity.
1
Additional
channels
CH14
CH13
CH12
CH11
CH10
CH9
CH8
CH7
CH6
CH5
CH4
CH3
BATT
Use only a speed controller which has the exclusive connector for
the BEC system.
Connector motor
Connector battery
Power switch On-/Off
Steering servo Channel 1
(not included)
ATTENTION
Make sure that male and female
connectors have the correct polarity!
Receiver
Do not connect a separate power supply
to the receiver!
3. Close the cover on the battery compartment again. Ensure
that the cover clicks properly into place. Check that it is in its
correct position.
2
17 // GB