Silvercrest SSH 600 A1 Bedienungsanleitung Seite 89

Protective devices
Overheating protection
The appliance is fitted with an overheating protector. If the appliance
becomes too hot internally, the heating element and fan switch off
automatically. In this case, pull the appliance out of the mains socket
and let it cool down for 30 minutes. Then plug the appliance back
into the mains socket and switch it on again.
WARNING! Overheating can lead to a risk of fire!
Check that the appliance can sufficiently dissipate the heat
generated: Is the appliance covered, are the ventilation slots
blocked or is the fan blocked?
If possible, eliminate the problem or contact the Service Hotline
(see the section Service).
Tilt cut-out
The fan heater must always be plugged into a mains socket in an
upright position, with the display 3 at the top. The tilt cut-out switch-
es the appliance off as soon as it is tilted by a few degrees from
the upright position. As soon as the appliance is back in an upright
position, it can be switched back on again.
│ GB │ MT
■ 86
SSH 600 B2