Silvercrest SSH 600 A1 Bedienungsanleitung Seite 88

Setting the heating/blower level
The fan heater has two combined heating/blowing levels.
♦ With the appliance switched on, press the setting button
(high heating/blower level) appears on the display 3 .
once.
♦ Press the
high heating/blowing level (
level ( ).
♦ Wait about 5 seconds. The information is automatically taken
over.
Set heating time
The appliance has a timer that you can use to set the desired heating
time between 1 to 24 hours. Once this heating period is over, the
appliance automatically switches to standby mode.
♦ With the appliance switched on, press the setting button
4 twice. The indication 3 flashes in the display (continu-
ous operation).
♦ Press the
duration in steps of 1 hour.
♦ Press the
duration in steps of 1 hour.
Note: After approx. 5 seconds without a button being pressed,
the set heating duration is accepted and the timer is activated.
When the timer is activated, the display 3 switches every few
seconds between the set temperature and the heating duration
display.
SSH 600 B2
button 7 or the
button 7, button repeatedly to increase the heating
button 2, button repeatedly to reduce the heating
button 2, to switch between the
) and the low heating/blowing
GB │ MT
4
│
85
■