Restore Factory Settings - HomeMatic HmIP-MOD-HO Installations- Und Bedienungsanleitung

Restore factory settings

1x long red
lighting
6x long red
flashing
1x orange
and 1x green
lighting (after
power supply
is applied)
7 Restore factory settings
The factory settings of the device can be restored.
If you do this, you will lose all your settings.
To restore the factory settings of the module, proceed
as follows:
Press and hold down the system button (A) for
•
4 seconds (see figure 8) until the device LED (A)
starts to flash orange quickly.
• Release the system button again (see figure 9).
• Press and hold down the system button again
for 4 seconds, until the LED lights up green (see
figure 10).
• Release the system button to finish the procedure.
The device will perform a restart.
32
Transmission
failed or duty
cycle limit is
reached
Device de-
fective
Test display
Try again (see sec. "6.1
Command not con-
firmed" on page 30
or "6.2 Duty cycle" on
page 30).
Have a look at your app
for error message or
contact your retailer.
Once the test display
has stopped, you can
continue.